Hi,
I am trying to bring up a pair of VSC9531 PHYs on an embedded system. I'm using a Yocto build and have altered the device tree with the following patch:
https://github.com/MistySOM/meta-mistysom/blob/phy-enable/recipes-kernel/linux/smarc-rzg2l/0001-add-vsc8531-userspace-dts.patch
I installed mdio-tools and can see the interfaces like:
# mdio
11c20000.ethernet-ffffffff
11c30000.ethernet-ffffffff

Also, I hooked up a logic analyzer to the mdio lines and can see communications happening at boot time. Also, it appears that it's able to read the link status correctly (when a cable is plugged):
# mdio 11c20000.ethernet-ffffffff
DEV PHY-ID LINK
0x00 0x00070572 up

Yet, ifconfig doesn't show the interfaces and I get:
# ifconfig eth0 up
[ 140.542939] ravb 11c20000.ethernet eth0: failed to connect PHY
SIOCSIFFLAGS: No such file or directory
When I try to bring it up

# ip l displays the interfaces as:
4: eth0: <BROADCAST,MULTICAST> mtu 1500 qdisc noop state DOWN mode DEFAULT group default qlen 1000
link/ether 9a:ab:83:16:65:36 brd ff:ff:ff:ff:ff:ff
5: eth1: <BROADCAST,MULTICAST> mtu 1500 qdisc noop state DOWN mode DEFAULT group default qlen 1000
link/ether 2a:9d:bf:09:8d:c3 brd ff:ff:ff:ff:ff:ff

Where am I going from here? I have experimented with drilling down into bitwise analysis of the MDIO communications. I'm uncertain though if this is my best bet, does someone here have any insight and can provide me with some guidance?

Thanks a lot!
Ron

--- MBSE BBS v1.0.8 (Linux-x86_64)
* Origin: ---:- FTN<->UseNet Gate -:--- (3:633/280.2@fidonet)